Using your IP Deskphone

1.Form a small bend in the cable.

2.Thread the adapter cord through the channels in the stand.

To use PoE, your connected LAN must support PoE. A PoE-enabled LAN delivers power to your IP Deskphone over the CAT-5 network cable and an AC adapter is not required.

WARNING

If you are connected to a PoE connection do not use the AC power adapter

To use gigabit Ethernet, you must connect to the LAN through CAT-5e (or later) cables.

Connecting the handset

Use the following procedure to connect the handset to the IP Deskphone.

1.Connect the end of the handset cable with a short straight section to the handset.

2.Connect the end of the handset cable with the long straight section, into the RJ-9 handset jack marked with the + symbol on the back of the IP Deskphone.

3.Form a small bend in the cable.

4.Thread the handset cord through the channels in the stand so that it exits behind the handset on the right side, using the handset cord exit in the stand base marked with the + symbol as shown in Figure 11 on page 57.

58

Page 58
Image 58
Avaya NN43113-101 manual Connecting the handset