Using your IP Deskphone

Method A:

1.Press the wall-mount lever, and pull the IP Deskphone away from the stand, as shown in Figure 13 on page 63.

2.Use the stand cover (the part you removed in “Removing the stand cover” on page 56), to mark the wall-mount holes by pressing the bottom of the stand cover firmly against the wall in the location where you wish to install the IP Deskphone. Four small pins on the bottom of the stand cover make marks on the wall.

3.Use the marks as a guideline for installing the wall-mount screws (not provided). Install the screws so that they protrude 3 millimeters (mm) (1/8 inch) from the wall.

4.Install the IP Deskphone stand mounting holes over the screw heads as indicated in Figure 12 on page 61 (Method A). You need to remove the IP Deskphone from the wall to adjust the lower screws.

5.When the lower screws are snug, install the IP Deskphone on the mounting screws, and then tighten the top screws.

62

Page 62
Image 62
Avaya NN43113-101 manual Method a