Kodak 8650 manual Setting up the printer, Applyfirm, even pressure

Setting up the printer

4.To clean the print head, first use the water pad and then use the alcohol pad. With each pad, wipe along the heater line four times as follows:

—Wipe the full length of the glass area (always in one direction). —Use a clean part of the pad for each wipe.

—Apply firm, even pressure.

—Wipe the metal roller bar and rod as shown.

Metal roller bar

Metal bar

Header line

AVOID METAL

EDGE!

Rod

5.Allow the glass area to dry for about two minutes.

6.Do one of the following:

If reloading the ribbon, load the supply spool first (with the bar code on the left. If the ribbon gets dirty or is damaged, wind the take-up spool ahead to the next clean magenta section.

If loading a new ribbon, refer to the instructions on the ribbon package.

7.Close the printer cover, and turn the printer On.

October 1997 2-7