Chapter 2
Using the control panel
Adjusting the control panel position
The position of the control panel can be adjusted from its default position (flush against the front of the printer) to lifted upward at an angle.
To adjust the control panel position:
1On the rear side of the control panel, locate the release tab.
2Press the front of the control panel and the release tab toward each other with your thumb and fingers; maintain this position and pull the control panel toward you gently.
3When you are satisfied with the position of the control panel, let go.
4To return the control panel to its default position, squeeze the release tab and gently push the control panel away from you. Let go when the panel is seated against the front panel of the printer.
About the “touch-sense” buttons on the control panel
The ESP 9
If this type of interface is unfamiliar to you, it may take a bit of practice getting used to it. You should discover that each button is quite sensitive to touch, and you may find that pressing a key too hard, or accidentally pressing one button several times in a row, may cause errors.
With practice, you will learn the right amount of pressure and the best rate for pressing the keys for using the buttons quickly and easily.
Tip: Make sure that the Printer Sounds option (available in the Printer Settings menu) is set to ON when learning to use the printer. With sound enabled, the printer gives you audible feedback when you press any button on the control panel.
Kodak ESP 9 Printer User Guide | 11 |