Kodak ESP 9 manual Configuring network settings, Configuring an Ethernet network connection

Models: ESP 9

1 141
Download 141 pages 3.04 Kb
Page 34
Image 34
Configuring network settings
until Network Settings is selected, and then press OK.

Setting Up Your Printer

Configuring network settings

You can connect your ESP All-in-One printer to a wired (Ethernet) network or to a wireless (WiFi) network. You may refer to the “Start Here” booklet that came with your printer, or review the following sections as needed.

Configuring an Ethernet network connection

You will need the following items to connect the All–in–One printer printer to a wired (Ethernet) network:

A functional Ethernet network that includes a router, switch, or hub with an Ethernet port.

A CAT-5 (or higher) Ethernet cable

Ethernet setup

1Plug one end of the Ethernet cable into the Ethernet port located on the back of the All– in–One printer and the other end into an available port on your Ethernet router or hub.

2Turn on the printer, if necessary.

3From the control panel, press Menu.

4 Press

5If you see the setting: Turn WiFi Radio Off, press OK now. This disconnects any existing wireless (WiFi) network connections.

6Use the Manual IP Address to change the IP Address. See your network provider for assistance.

Configuring a wireless network connection

You can connect your printer to a 802.11 wireless (WiFi) network from the All-in-One printer control panel.

26

Kodak ESP 9 Printer User Guide

Page 34
Image 34
Kodak ESP 9 manual Configuring network settings, Configuring an Ethernet network connection, Ethernet setup