Response allows you to specify the action that will be taken when the transport timeout has been reached.
•Stop Feeder and Transport: stops the feeder and the transport but leaves the scanner enabled. Scanning may be resumed by pressing the Start/Resume button.
•End Job: stops the feeder and the transport and disables the scanner. Scanning cannot be resumed until the scanner is enabled by the host.
Enabling Lamp Saver mode Enabling Lamp Saver extends lamp life and reduces energy consumption. This value is the amount of time (in minutes) the scanner will wait after the last document enters the transport before the lamps will turn off. If enabled, you can specify a time delay setting from 1 to 30 minutes. The default is 10 minutes. If this option is disabled, the lamps will remain on until the power is turned off.
Assigning Function Keys This section is used to assign actions the operator uses from the Operator Control Panel. Function Key #1, Function Key #2 and Function Key #3.
Available functions are:
•
•Terminate Batch
•Omit
•Do not Print on Next Document
•Omit Patch Reading on Next Document
|
