3. Determine if any changes to the Image Processing parameters need to be made for the current application.

NOTE: This check needs to occur for up to four separate images from the six available options depending on your application: Front Color, Front Bi-tonal, Front Grayscale, Rear Color, Rear Bi-tonal, Rear Grayscale.

Image Processing parameter changes remain in effect until one of the following conditions occur:

The scanner is powered down using the power switch.

A SCSI bus device Reset command is executed.

New imaging parameters are sent from the host.

 

4. It is recommended that you calibrate the scanner. For

 

procedures on how to do this, see the Kodak i800 Series

 

Scanners, User’s Guide.

 

5. Prepare documents according to the instructions found in the

 

Kodak i800 Series Scanners, User’s Guide.

Enable scanning

The host must issue a Scan command to enable scanning before

 

documents can be transported through the scanner. If scanning has

 

not been enabled, the feeder and transport system will not turn on.

Initiate polling

Initiate host system polling of the scanner to ensure scanned

 

document images are transferred from the image buffer to the host

 

system. Polling should continue until scanning is disabled.

 

For more information see the sections entitled, “Controlling

 

image transfer order” and “Image header information” later in this

 

chapter.

Feed documents

Feed documents according to the instructions found in the Kodak

 

i800 Series Scanners, User's Guide.

A-61510 January 2005

2-3

Page 9
Image 9
Kodak i800 Series manual Enable scanning, Initiate polling, Feed documents