Kodak i800 Series manual Message

Message	Description
Message	Mechanical cal unsuccessful
Action	The mechanical calibration was unsuccessful. Be sure the correct calibration
	target was used and that the arrows on the target were feed into the transport first.
	See Chapter 3, Operator Control Panel Functions, “Calibration” for more
	information.
Message	Motor self test failed
Action	The self-test of the paper transport motor failed. Perform a controlled power-down
	sequence on the scanner. If the problem persists, call Service.
Message	Multi-feed count:
Action	Informational message. Displays the multi-feed count from the “Count only” mode.
Message	Multi-feed detected
Action	A multi-feed has been detected due to a length checking condition or an ultrasonic
	multi-feed condition. Depending on how your scanner is programmed, you may
	need to restart the scanner from your host computer. Always check your host
	monitor to verify images as overlapped documents may need to be rescanned.
	This condition may be caused by poor document separation; replace the
	separation roller tires and pre-separation pad. See Chapter 5, Maintenance for
	instructions.
Message	Multi-feed failed self test
Action	A multi-feed detection subsystem has failed self-test. You can still scan
	documents, but multi-feed detection will not work. Perform the self-test again or a
	controlled power down sequence. If the problem persists, call Service.
Message	Multi-feed cal unsuccessful
Action	The multi-feed calibration failed. Be sure the sensors are clean and that the
	correct calibration target is used. Retry calibration. See Chapter 5, Maintenance,
	“Cleaning the Transport area” for cleaning procedures. See the diagram at the end
	of this document for the approximate location of sensors. Also see Chapter 3,
	Operator Control Panel Functions, “Calibration” for more information.
Message	No paper in tray
Action	An attempt was made to start the scanner with no paper in the elevator tray. Place
	paper in the elevator tray and restart.
Message	Page count:
Action	Informational message. Displays the page count from the “Count only” mode.
Message	Patch count:
Action	Informational message. Displays the number of documents containing a patch
	from the “Patch Test” mode.
Message	Patch hardware not present
Action	The Patch Reader head is not properly connected to the scanner. Be sure the
	patch head is properly seated in position and try again. If the problem persists, call
	Service.
Message	Power-on self-test succeeded
Action	Informational message. The scanner self-test has been performed successfully.

6-8 A-61169 July 2003