Message

Description

Message

Print head not present

Action

An attempt was made to use the Document Printer and no print head is installed.

 

Be sure the cables are properly connected to the print head and printer board. Be

 

sure the print cartridge is installed in the print head assembly. See Chapter 4,

 

Document Printer and Patch Reader for procedures.

 

 

Message

Rear image cal unsuccessful

Action

The imaging calibration for the rear camera was unsuccessful. Clean the imaging

 

guides and retry calibration. See Chapter 5, Maintenance, “Cleaning the imaging

 

guides” for cleaning procedures.

 

 

Message

Refeed document set

Action

The documents are too close together as they enter the scanner. Replace the

 

separation roller tires and pre-separation pad. See Chapter 5, Maintenance for

 

instructions.

 

One or more documents that passed through the transport were not scanned.

 

Refeed all documents for which images were not obtained.

 

A hole or tear in the document triggered a false count on the exit sensor. Align

 

documents so that holes and tears do not pass beneath the left feed tire.

 

 

Message

Replace lamps soon

Action

You will need to replace all four lamps soon. See Chapter 5, Maintenance

 

regarding lamp replacement procedures.

 

 

Message

S1 sensor is blocked

Action

A document may be blocking the S1 sensor. Clear the paper path by following the

 

procedures outlined earlier in this chapter. See the diagram at the end of this

 

document for the approximate location of this sensor.

 

 

Message

S2 sensor is blocked

Action

A document may be blocking the S2 sensor. Clear the paper path by following the

 

procedures outlined earlier in this chapter. See the diagram at the end of this

 

document for the approximate location of this sensor.

 

 

Message

Self-test failed

Action

One of the scanner subsystems failed self-test. The subsystem’s functionality will

 

not be available. Turn the power off and on again and perform another self-test. If

 

the problem persists, call Service.

 

 

Message

Self-test passed

Action

Informational message. The self-test performed was successful.

 

 

Message

Sequential count overflow

Action

The sequential count overflowed. Reconfigure the scanner to allow a larger value

 

for sequential count.

 

 

Message

Settings conflict

Action

Conflicting or unacceptable settings have been downloaded to the scanner. For

 

example, if you attempt to set a 200 dpi bi-tonal front with a 300 dpi bi-tonal rear or

 

if you try to enable color scanning on a Kodak i810 or i830 Scanner.

 

 

A-61169 July 2003

6-9

Page 77
Image 77
Kodak i800 Series manual Message Description Print head not present Action, Message Rear image cal unsuccessful Action