Kodak i800 Series manual Maintenance and replacement procedures

Maintenance and replacement procedures

A-61169 July 2003

This section provides procedures for replacing the following parts. Use the list below as a guideline for frequency of replacement.

∙Feed Module Tires and Separation Roller – tire life will vary depending upon paper types, environment and cleanliness. Nominal tire life will be approximately 250,000 documents; results will vary. Degradation of feeder performance, multiple feeds, stoppages, etc. indicate a need to change tires. Change all the tires on the feed module and separation roller at the same time.

∙Feed Module Separation Roller – it is recommended that you install a new feed module approximately every 5th tire change. See the checklist included in the Replenishment Kit. Install a new feed module and separation roller at the same time.

∙Pre-separation Pad – change each time you change the tires on the feed module and separation roller.

∙Exposure Lamps – it is suggested that all four lamps be replaced every 500 hours of operation or as necessary (i.e., as reported by the scanner, repeated image calibration failures, etc.)

∙Imaging Guides – replace when the imaging guides are heavily scratched and defects show in the image.

This section also provides replacement procedures for the:

∙Gear for Self-Centering Side Guides – a spacer is installed in the output tray, which allows the side guides to move independently. If you want the side guides to move together (self-centering) you can install the geared spacer that is included with the scanner.

∙Side Guides – short side guides are standard with the scanner. A set of tall side guides is included with your scanner and can be changed as required by your application.

5-11