4. Select Return.
5.Use the up and down arrows to select the desired SCSI termination setting.
6.Select Return.
7.Turn the scanner off. Wait at least 10 seconds and turn the scanner back on again. The new termination setting will take effect.
Setting the elevator tray This setting allows you to select a position of the elevator tray. Elevator
positionpositions can be set to accommodate
unless the Override Elevator icon (
) is selected.
NOTE: The setting of 25 should be used for manual or continuous feed operation.
To set the elevator tray position:
1.Select the Diagnostics Settings menu 
icon.
2.Use the right or left arrow to navigate to the Settings function.
3.Press the down arrow until Set elevator position is displayed on the Operator Control Panel.
|
