Scanning documents | Before you scan documents, be sure the menu bar is displayed on the |
| Operator Control Panel. |
Operator Control
panel
Documents must be fed under both feed module tires. For faster throughput, feed documents into the elevator tray in landscape orientation (longer side as the leading edge).
To start scanning:
1.Enable the scanner from the host.
2.Place the documents to be fed in the elevator tray.
3.Press Start/Resume .
Start/Resume
Stop/Pause
NOTES:
∙Documents must be fed under both feed module tires.
∙Do not lean on the elevator tray and/or document extenders while the scanner is running. If this happens, the elevator tray may make some noise and stop in position. See the Problem Solving Chart in Chapter 6, Troubleshooting/Messages for procedures on recovery from this situation.
∙Use caution when feeding small documents; small documents may fall through the slots of the elevator tray and cannot be easily retrieved.
To stop scanning:
∙Press Stop/Pause.
|