Korg KONTROL49 owner manual Slider Slider assignment, PAD 1-8 PAD 1-8 assignment

Operation–Setting mode

[2] SLIDER (Slider assignment)

In the Slider assignment page, you can assign MIDI messages to sliders and specify the MIDI channel on which the messages will be transmitted, etc. You can assign a control change (CC#), RPN, or NRPN message to each slider.

1	Hold down the [SETTING] key and press pad [2].
	You will be in the Slider assignment page, and the [SETTING] key and

pad [2] will light. The main display indicates “Slider Select” (select the slider to assign). The messages you can assign to a slider and the assignment procedure are the same as for an encoder. For details, refer to “Encoder assignment” (☞p.20).

You can use the Quick Assign procedure for sliders as well. For details, refer to “Quick-assign for control changes” in “Encoder assignment.”

[3] PAD 1–8 (PAD 1–8 assignment)

PAD 1–8 assignment lets you assign MIDI messages to pads 1 through 8, and specify the channels on which these messages will be transmitted.

You can assign a note message or a control change (CC#) to each pad.

If you assign a control change, the message will be transmitted with a value of either 0 or 127.

Pad velocity settings are maintained separately for each scene. As the pad velocity type, you can choose either to transmit a velocity value that corresponds to the force with which you strike the pad, or to transmit a fixed value regardless of your striking force.

1	Hold down the [SETTING] key and press pad [3].
	Now you can make pad [1]–[8] assignments. The [SETTING] key and

pads [1] through [8] will light/blink. The main display will indicate “PAD# 01” (select the pad that you want to assign).

Sub-displays 1 through 8 will show the MIDI transmit channel, MIDI message, and pad transmission setting for each pad.

	MIDI channel MIDI message type Note number Pad operation type
	or
	Control change number
	For example if you operate the fifth encoder or slider, PAD#5 will be
	selected and the main display will indicate “PAD# 05”.
2	Use the main encoder or the pads to select the pad that you want to
	assign. To make your selection using the pads, simply press the desired

pad.

The pad selected for assignment will blink.

	If both SW1 and 2 are lit, you can also use these switches to select a pad
	to assign.
	In the following pages where you specify the MIDI message type and
	note number or control change number, you can use the
	correspondingly-numbered encoder or slider to select a parameter or
	edit a value. It’s convenient to use the slider to make large changes in a
	value, and use the encoder to make fine adjustments.
3	Press the OCTAVE SHIFT/CURSOR [®] key to proceed to “Message
	Select” (select the MIDI message).

(Red) (Green)

24