Lanier 5622 AG Interface Settings/Parallel Interface, Parallel Timing, Selection Signal Status

Settings You Can Change with the User Tools

Interface Settings/Parallel Interface

❖Parallel Timing

Specifies the timing setting for the parallel interface. Under normal circum- stances, you will not need to change this setting.

Note

❒ Default: ACK outside

❖Parallel Communication Speed

Specifies the communication speed for the parallel interface. If the communi- cation speed is set too fast, data transfers may not flow smoothly. If this oc- curs, change the setting to “Standard”.

Note 4

❒Default: High speed

❖Selection Signal Status

Specifies the level for the select signal setting of the parallel interface.

Note

❒Default: High

❖Input Prime

Specifies whether the prime signal is active or inactive when an input prime signal is sent. Under normal circumstances, you will not need to change this setting.

Note

❒Default: Invalid

❖Bidirectional Communication

Specifies the printer's response mode and so forth for a status request when using the parallel interface. If you experience problems when using other manufacturers printers, set this to “Off”. However, if this is set to “Off”, asyn- chronous functions will not work.

Note

❒Default: Yes

❖Signal Control

Specifies the error processing settings for when an error occurs when printing from a computer or sending faxes. Under normal circumstances, you will not need to change this setting.

Note

❒Default: Job acceptance priority

81