Put the lamp holder with burner inserted into the lamphousing and secure with the screws (90.10).

Close the lid of the lamphousing. When closing the lamphousing, make sure that the pins of the cut-out plug engage in the sockets.

Retighten the screws of the lid.

Push the cut-out plug in as far as it will go.

Align the lamphousing against the microscope and secure with the clamp screw.

Connect the lamphousing to the power unit (compare mains voltage!).

Fig. 90 Lamp holders for gas discharge lamps

1Upper clamp, 2 Seal point of the burner, 3 Lower clamp, 4, 6 Drill holes for fixing the lamp holder, 5 Sockets for cut-out plug,

7Protective cover

Hg 50

 

 

 

Xe 75

1

 

 

 

 

 

 

 

 

1

 

 

 

 

 

 

 

 

 

 

 

 

 

 

7

 

 

 

 

 

2

 

 

 

 

 

 

 

 

 

 

 

3

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

4

 

 

 

 

 

 

 

3

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

5

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

6

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Hg 100

1

3

Hg 100 Stab.

1

3

111

Page 111
Image 111
Leica DM IRB manual 111, Lamp holders for gas discharge lamps