Lexmark 920 Printing a font sample list, Printing a directory list, Printing a network setup page

Printing

Printing a network setup page

If the printer is attached to a network, print a network setup page on the printer to verify the network connection. This page also provides important information that helps in configuring for network printing.

1Make sure the printer is on.

2Press on the operator panel.

3Press until Reports appears, and then press .

4Press until Network Setup Page appears, and then press .

Note: If an optional MarkNet N8000 series internal print server is installed, Print Net1 Setup appears on the display.

5Check the first section on the network setup page, and confirm that Status is “Connected.”

If Status is “Not Connected” is on the page, the LAN drop may not be active, or the network cable may be malfunctioning. Consult a system support person for a solution, and print another network setup page to verify that the printer is connected to the network.

Printing a font sample list

To print samples of the fonts currently available for your printer:

1Make sure the printer is on and the Ready message appears.

2Press on the operator panel.

3Press until Reports appears, and then press .

4Press until Print Fonts appears, and then press .

5Press until the appears next to PCL Emul Fonts, PostScript Fonts, or PPDS Fonts, and then press

.

Printing a directory list

A directory listing shows the resources stored in flash memory or on the hard disk. To print a listing:

1Make sure the printer is on and the Ready message appears.

2Press on the operator panel.

3Press until Reports appears.

4Press .

5Press until Print Directory appears.

6Press .

The message Printing Directory List appears on the display. The printer returns to the Ready state after the directory list prints.

Printing a network setup page

55