Lexmark 920 manual Adjusting Power Saver, Encrypting the disk, Administrative support

Administrative support

Adjusting Power Saver

To adjust the Power Saver setting:

1Make sure the printer is on and Ready appears on the display.

2Press on the operator panel.

3Press until Settings appears, and then press .

4Press until Setup Menu appears, and then press .

5Press until Power Saver appears, and then press .

6Using the numeric pad or the right and left arrows on the operator panel, enter the number of minutes for the printer to wait before entering Power Saver.

The settings available range from 2–240 minutes.

7Press .

Submitting Selection appears.

Note: You can also adjust the Power Saver setting by issuing a Printer Job Language (PJL) command. For more information, see the Technical Reference available on our Lexmark Web site at www.lexmark.com.

Encrypting the disk

Warning: All resources on the hard disk will be deleted. (Resources residing in flash memory or in RAM remain unaffected.)

Note: This setting is only available when a hard disk is installed.

1Turn the printer off.

2Press and hold and while turning the printer on.

3Release both buttons when Performing Self Test appears on the display.

The printer performs its power-on sequence, and then Config Menu appears on the first line of the display.

4Press until Disk Encryption appears, and then press .

5Press until Enable appears, and then press .

Contents will be lost. Continue? appears.

6Press until Yes appears, and then press . The Encrypting Disk progress bar appears.

7When disk encryption has finished, press .

8Press until Exit Config Menu appears, and then press .

To disable disk encryption:

1Turn the printer off.

2Press and hold and while turning the printer on.

3Release both buttons when Performing Self Test appears on the display.

The printer performs its power-on sequence, and then Config Menu appears on the first line of the display.

4Press until Disk Encryption appears, and then press .

Adjusting Power Saver

132