Return to Section TOC
Return to Section TOC
Return to Master TOC
Return to Master TOC
F-63 TROUBLESHOOTING AND REPAIRF-63
DC BUS BOARD REMOVAL AND REPLACEMENT (continued)
FIGURE F.28 CASE FRONT SCREW REMOVAL
STATUSTHERMAL
Phillips Head |
| Phillips Head |
| Screws | |
Screws | _ | + |
| ||
|
| |
|
| 5/16" |
|
| Mounting Screws |
Section TOC
Master TOC
9.Label and remove two thermostat leads and four leads from the bus rectifier.
10.Using a 3/8” open end wrench, remove the three DC Bus Board mounting nuts. See Figure F.29.
11.Replace the DC Bus Board.
12.Secure the new DC Bus Board in its proper loca- tion using the 3/8” mounting nuts.
13.Reconnect previously removed leads to their prop- er locations.
14.Replace the four phillips head screws mounting the two welder output terminals to the front of the machine.
15.Replace the two phillips head screws from above and below the input power switch.
FIGURE F.29 CASE FRONT SCREW REMOVAL
Return to
to Section TOC
Return to
Return to Master TOC
3/8" Mounting
Nuts
J47 |
Bus |
Rectifier |
Thermostat |
J46 |
Return
