TOC

TOC

F-62

TROUBLESHOOTING AND REPAIR

F-62

 

DC BUS BOARD REMOVAL AND REPLACEMENT (continued)

 

Return to Section

TOC

Return to Master

TOC

PROCEDURE

1.Remove input power to the POWER WAVE 355M/405M.

2.Using a 5/16” nut driver remove the case wrap- around cover.

3.Perform the Input Filter Capacitor Discharge Procedure detailed earlier in this section.

4.Locate the DC Bus Board. See Figure F.27.

5.Using a 5/16” nut driver remove the two screws from the bottom of the front of the machine. See

Figure F.28.

6.Using a phillips head screwdriver remove the two screws and their washers from above and below the input power switch. See Figure F.28.

7.Using a phillips head screwdriver remove the four screws mounting the two welder output terminals on the front of the machine. See Figure F.28.

8.The front of the machine may now gently be pulled forward to gain access to the DC Bus Board. Note: The front of the machine cannot be removed completely, only pulled forward a few inches.

Return to Section

Return to Master

FIGURE F.27 DC BUS BOARD LOCATION

DC BUS BOARD

Return to Section TOC

Return to Section TOC

Return to Master TOC

Return to Master TOC

STATU

S

THERM

AL

LI

 

NC

 

OL

EL

N

EC

 

TRI

 

C

WARNING

 

REMOTE

POWER

ON

OFF

POWER WAVE 355M/405M

Page 108
Image 108
Lincoln Electric 405M, 355M service manual DC BUS Board Removal and Replacement