INSTALLATION |
Return to Section TOC
Return to Section TOC
Return to Section TOC
Return to Master TOC
Return to Master TOC
Return to Master TOC
SAFETY PRECAUTIONS
WARNING
ELECTRIC SHOCK can kill.
•TURN THE INPUT POWER OFF AT THE DISCONNECT SWITCH BEFORE ATTEMPTING TO CONNECT OR DIS-
CONNECT INPUT POWER LINES, OUTPUT CABLES, OR CONTROL CABLES.
•Only qualified personnel should perform this installation.
•Connect the green/yellow lead of the power cord to ground per U.S.National Electrical Code.
SELECT SUITABLE LOCATION
In order to assure long life and reliable operation, the owner of this machine should follow these sim- ple preventative measures:
•The machine must be located where there is free cir- culation of clean air such that air movement in the back, out the sides and bottom will not be restricted.
•Dirt and dust that can be drawn into the machine should be kept to a minimum. Failure to observe these precautions can result in excessive operating temperatures and nuisance shutdown.
•Keep machine dry. Shelter from rain and snow. Do not place on wet ground or in puddles.
CAUTION
•DO NOT MOUNT OVER COMBUSTIBLE SURFACES. Where there is a combustible surface directly under stationary or fixed electrical equipment, that surface shall be covered with a steel plate at least .06”(1.6mm) thick, which shall extend not less than 5.90”(150mm) beyond the equipment on all sides.
STACKING
POWER WAVE 355M/405M cannot be stacked.
TILTING
Place the machine directly on a secure, level surface or on a recommended undercarriage. The machine may topple over if this procedure is not followed.
INPUT AND GROUNDING CONNECTIONS
•Open the access panel on the rear of the machine.
•For 200 or 230: Position the large switch to 200- 230.
For higher voltages: Position the large switch to
•Move the "A" lead to the appropriate terminal.
POWER CORD CONNECTION
A power cord is provided and wired into the machine. Follow the power cord connection instructions.
Machine | Cord | Length |
PW 355 | 10 | Feet |
PW 405 | 5 Meters | |
CAUTION
•Incorrect connection may result in equipment damage.
A
V |
LINCO
ELECLN
TRIC
I |
|
NVERTEC | V350- |
| |
| PRO |
Single Phase Input (PW 355M)
Connect green lead to ground per National Electrical Code.
Connect black and white leads to power.
Wrap red lead with tape to provide 600V insulation.
Three Phase Input (PW 355M)
Connect green lead to ground per National Electric Code.
Connect black, red and white leads to power.
Lead Color | Single Phase | Three Phase |
Green | Connect to | Connect to |
| ground per NEC | ground per NEC |
|
|
|
Black | Power Lead | Power Lead |
|
|
|
White | Power Lead | Power Lead |
Red | Tape, provide | Power Lead |
| 600V insulation |
|
|
|
|
Return to Master TOC
•Only a qualified electrician should connect the POWER WAVE 355M/405M. Installation should be made in accordance with the appropriate National Electrical Code, all local codes and the information detailed below.
•When received directly from the factory, multiple volt- age machines are internally connected for the highest voltage. Always
•Initial 200VAC - 415VAC and 575VAC operation will require an Input voltage panel setup.
Single Phase Input (PW 405M)
Connect green/yellow lead to ground per National Electrical Code.
Connect blue and brown leads to power.
Wrap black lead with tape to provide 600V insulation.
Three Phase Input (PW 405M)
Connect green/yellow lead to ground per National Electric Code.
Connect black, blue and brown leads to power.
Return
POWER WAVE 355M/405M
