Return to Section TOC
Return to Section TOC
Return to Master TOC
Return to Master TOC
TROUBLESHOOTING AND REPAIR | ||
| CONTROL BOARD REMOVAL AND REPLACEMENT (continued) |
|
FIGURE F.19 - CONTROL BOARD ALL PLUG LOCATIONS
J5 J6 J7 J8
J9 
J4
J2
|
| ST |
|
|
|
| AT |
|
|
|
| US |
|
|
|
| T |
|
|
|
| HE |
| J10B |
|
| RM |
| |
|
| AL |
| |
ELELN |
|
|
| |
LI |
|
|
|
|
NC |
|
|
|
|
O |
|
|
|
|
CT |
|
|
|
|
RI |
|
|
|
|
C |
|
|
|
|
WARNING |
|
|
| J10A |
| REMOTE |
|
| |
|
|
| PO | WER |
|
|
|
| |
|
| ON |
|
|
|
| OFF |
|
|
Return to Section TOC
to Section TOC
Return to Master TOC
Return to Master TOC
CAUTION
Observe static precautions detailed in PC Board Troubleshooting Procedures at the beginning of this section.
6.Using a phillips head screwdriver remove the two screws and their washers from above and below the input power switch. See Figure F.18.
7.Using a phillips head screwdriver remove the four screws from around the two welder output termi- nals on the front of the machine. See Figure F.18.
8.The front of the machine may now gently be pulled forward to gain access to the Control Board. Note: The front of the machine cannot be removed completely, only pulled forward a few inches.
9.Beginning at the right side of the control board remove plugs J10A and J10B. Note: Be sure to label each plugs position upon removal. See Figure F.19.
10.Working your way across the top of the board from right to left, label and remove plugs #J9, #J8, #J7, #J6, and #J5. See Figure F.19.
11.Working your way down the left side of the board, label and remove plugs #J4 and #J2. See Figure F.19.
Return
