Return to Section TOC

Return to Section TOC

Return to Section TOC

Return to Section TOC

Return to Master TOC

Return to Master TOC

Return to Master TOC

Return to Master TOC

A-6

A-6

INSTALLATION

Figure A.8 is a connection diagram for connecting the LN-9 GMA to V300 power sources. The connection is made with a K596 cable assembly, which has an amphenol connection rather than a terminal strip con- nection at the power source.

Depending on the power source and process you are using, the jumpers on the LN-9 GMA voltage board may have to be changed. As shipped, the LN-9 GMA is connected for use with the DC-250 DC-400, CV-400, CV-500-I and DC-600. For other power sources, refer to the appropriate connection diagram.

NOTE: If you are using the Pulse Power 500, DC650 Pro, or V300 power source, the K442-1 Pulse Power Filter Kit must be installed in the LN-9 GMA. See the instructions included with the kit. If you are using the Invertec V300, the K608-1 Adapter must also be installed according to the connection diagram and instructions provided in the Invertec Manual.

LN-9 GMA Wire Feeder

Page 14
Image 14
Lincoln Electric SVM138-A service manual Installation