OPERATION |
Return to Section TOC
Return to Section TOC
Four items show on the MSP4 panel.
•Memory Value
•High Limit
•Low Limit
•Parameter Name
One of these items will flash to indicate which item will change when the MSP4 encoder is rotated. Press the right button on the MSP4 panel to select the item to change.
Memory Value |
| High Limit |
| Low Limit | |
|
| |
| WAVEFORM CONTROL TECHNOLOGY | |
IR PORT | 200Lo == | 180200 |
| Hi |
|
|
| SETUP |
| Weld WFS | |
WELD MODE |
| START OPTIONS |
ARC CONTROL |
| END OPTIONS |
SET
Parameter Name
The memory value must always be less than or equal to the high limit, and greater than or equal to the low limit.
After setting limits, press the memory button with the flashing LED. The MSP4 will ask to save or discard the limit changes just made. Press the left MSP4 for but- ton (YES) to save and enable the limits and exit. Press the right MSP4 button (NO) to exit and leave limits unchanged.
Enabling/Disabling Limits
Enable/Disable
Limits: Press
10 seconds
MMEMORYM
PROCEDURE
A GUN B
1 2 3
HOLD 2 SECONDS TO SAVE
4 
5 
6 
Return to Section TOC
Return to Section TOC
Return to Master TOC
Return to Master TOC
Return to Master TOC
Return to Master TOC
The Limits Setup menu shows a list of all parameters available for the weld mode stored in the memory cho- sen. For example, if limits are being set for a stick (SMAW) mode, parameters such as
To lock a parameter to a specific value that cannot be changed, set the high and low limits to the same value.
| WAVEFORM CONTROL TECHNOLOGY | |
IR PORT | 200Lo == | 180200 |
| Hi |
|
|
| SETUP |
| Weld WFS | |
WELD MODE |
| START OPTIONS |
ARC CONTROL |
| END OPTIONS |
| SET |
|
| Rotate to | Press to |
| Change | select item |
| Value. | to change. |
Limits for each memory may be enabled or disabled by pressing and hold the appropriate memory button for 10 seconds. Release the memory button when the MSP4 display shows the following:
| WAVEFORM CONTROL TECHNOLOGY |
| Memory 1 |
IR PORT | Limits |
| SETUP |
| Enable/Disable |
WELD MODE | START OPTIONS |
ARC CONTROL | END OPTIONS |
| SET |
Press the left MSP4 button (YES) to enable limits or the right MSP4 button (NO) to disable limits. Disabling limits does not change any limits values that may have been previously set.
WAVEFORM CONTROL TECHNOLOGY
| Enable |
IR PORT | Limits? |
| SETUP |
Yes | No |
WELD MODE | START OPTIONS |
ARC CONTROL | END OPTIONS |
| SET |
