Return to Section TOC
Return to Section TOC
Return to Section TOC
Return to Section TOC
Return to Master TOC
Return to Master TOC
Return to Master TOC
Return to Master TOC
NOTES |
RETEST AFTER REPAIR
Retest a machine:
•If it is rejected under test for any reason that requires you to remove any part which could affect the machine’s electrical characteristics.
OR
• If you repair or replace any electrical components.
SET UP
1.Once the repairs have been completed, the feeder must be connected to a Powerwave® 455M power source, or simular ArcLink® power source.
2.Go to the Service Navigator under Diagnostic Utility and perform the status check proce- dure.
3.With the use of a load bank and the utility, all functions of the feeder can be tested.
