Return to Section TOC
Return to Section TOC
Return to Section TOC
Return to Section TOC
Return to Master TOC
Return to Master TOC
Return to Master TOC
Return to Master TOC
OPERATION | ||
| 11. |
|
The
WARNING
ELECTRIC SHOCK can kill.
• Turn the input power OFF at the welding power source before installation or changing drive rolls and/or guides.
• Do not touch electrically live parts.
• When inching with the gun trigger, electrode and drive mechanism are "hot" to work and ground and could remain energized several seconds after the gun trigger is released.
• Welding power source must be connected to system ground per the National Electrical Code or any applicable local codes.
• Only qualified personnel should perform mainte- nance work.
STATUS LED |
|
|
|
|
|
| STAT US |
| |
(See Table B.1) |
|
|
| |
|
|
| ||
|
|
|
| |
|
|
|
|
|
The status LED indicates system status. Normal oper- | ||||
ation is a steady green light. |
|
|
|
|
Note: During normal | ||||
and/or green as the equipment performs self tests. | ||||
| TABLE B.1 |
|
|
LED condition | Definition |
Steady green | System okay. The power source and wire feeder are communicating normally. |
Blinking green. | Occurs during a reset and indicates the power source is identifying each component in the system. This is |
| normal for up to 15 seconds after |
Blinking green, fast | Indicates that one or more pieces of ArcLink equipment are not mapping properly. Check the DIP switch set- |
| ting on the wire feeders. |
Blinking green fol- | |
lowed by blinking | red and green, errors are present in the system. Count the error code before the machine is turned |
red. | below. |
| Error codes are detailed in the Troubleshooting Section E. Individual code digits are flashed in red with a long |
| pause between digits. After each error code the LED will flash green and codes will repeat. There may be more |
| than one error code indicated. Record the red flash count (error code) for reference before turning unit off. |
| To clear the error, turn the power source OFF, and then back ON to reset. See Troubleshooting Section E. |
|
|
