Lucent Technologies Network Access Module manual Settings Example

Network Settings

•See “Set Up Additional WAN Ports” on page 6-7.

Table 2-2Basic Network Configuration Settings for the INA Module

Settings	Notes	Example
Ether0 address	IP address of the Ether0 port on the	192.198.32.2
	INA module.
Ether0 netmask		255.255.255.0
System name	Optional.	Mysystem
First data channel number	The data channel number determines	16
assigned to the router	the WAN port number, which is 1 (one)
	less that the data channel number. For
	example, if the first data channel
	number is 16, all subsequent channels
	are assigned to port W15.
Default gateway		192.198.32.1
Name service type	Optional. Select the Domain Name	DNS
	System (DNS) or Network Information
	Service (NIS).
Name server address	Optional.	192.12.35.1
WAN port address		192.198.32.40
Remote router address		172.12.32.2
Remote router netmask		255.255.255.240
Channel rate	This value is not handled by the	56k or 64k
	INAWizard. Use the command line
	interface or PMVision to set this value.
	The default speed is 64Kbps. Almost all
	installations use this default value.
Protocol	Point-to-Point Protocol (PPP) or Frame	Frame
	Relay.
Data link connection identifier	For Frame Relay connections only.	LMI
(DLCI) list source	Select Local Management Interface
	(LMI) or Annex-D, and/or manually
	enter a DLCI list.
DLCI keepalive value	For Frame Relay connections only.	20
	Change the 10-second default, if
	necessary, to match the value on the
	Frame Relay switch. Contact your telco
	for more information.

Getting Ready for Configuration 2-3