Lucent Technologies Network Access Module Board Renumbering, Print Reports, ConditionExplanation

INA Module System Interactions

Board Renumbering

The INA module works in the same manner as the 100D module for board renumbering. Use board renumbering to replace a 100D module with a 100R module, and vice versa. After the board renumbering, T1/PRI data that had been previously administered for the replaced module is associated with the new module. The data channels assigned to the 100R are now be unassigned on the 100D module.

￿Print Reports

The System Inventory Report is enhanced to include summary information about INA modules present in the system. This summary information is presented under the 100-RUlabel.

PCMCIA Flash Memory Card-Based Upgrade Operation

The INA module firmware is upgradeable using the MERLIN MAGIX PCMCIA card.

Note – Performing an upgrade to the INA module firmware using the MERLIN MAGIX PCMCIA card does not upgrade the INA module router software. Router software is upgraded separately with the PMVision application. Depending upon the nature of the upgrade, either a INA module firmware upgrade, or a router software upgrade, or both might be required.

Other System Interactions

Table C-5shows system conditions applying to the INA module.

Table C-5INA Module System Interactions

ConditionExplanation

Idle Conditions - The system might be forced into an idle state

System Forced while the module is routing data traffic. When

Idlethe system is in the forced idle condition, the router on the INA module continues to operate and route data traffic.

Slot Busy-OutAn INA module can be busied out even if the module is routing data traffic. Busying out the module disrupts both voice and router services. Voice and data services are restored when the module is restored.

C-8 INA Module Installation and Configuration Guide