Lucent Technologies Network Access Module manual Contents, Using the INAWizard

Contents

Connect a Serial Passthrough Cable	3-1
Set DIP Switches	3-2
Connect a Console (Optional)	3-3
Connect a T1/PRI Cable	3-3
Connect an Ethernet Cable	3-4
Observe LED Behavior	3-4
T1/PRI LEDs	3-4
System LED	3-5
Ethernet LEDs	3-6
4. Using the INAWizard
Install the Wizard	4-1
Connect the Workstation to the INA Module	4-1
Over a LAN	4-1
Using a Crossover Cable	4-2
Run the Wizard	4-2
5. Using the Command Line Interface
Connect a Console	5-1
Using the C0 Console Port	5-1
Using a Telnet Session	5-2
Using the Passthrough Serial Connection	5-2
Log In	5-2
Set the Administrative Password	5-2
Set the Ether0 Network Address	5-3
Set the IP Address and Netmask	5-3
Set the Broadcast Address	5-3
Set the System Name	5-4
Set the Default Route Gateway	5-4
Use Name Resolution (Optional)	5-4
Set Up a Local Host Table	5-4
Set a Name Service	5-4
Configure the WAN Port	5-5
Set the Channel Rate	5-6
Set Up Additional WAN Ports	5-6
Set the Port IP Address (Optional)	5-6

vi INA Module Installation and Configuration Guide