Lucent Technologies Network Access Module Edit System name INA→ Configure→ Snmp, Ports, Edit

Selecting PMVision Functions

Table 6-1Basic INA Module Configuration Using PMVision (Continued)

Setting	Select PMVision Function:	Entry
Ether0 netmask	INA→ Configure→ Ethernets,	IP netmask
	Edit
System name	INA→ Configure→ SNMP	System		name
Default gateway	INA→ Configure→ Global	IP gateway
Name service type	INA→ Configure→ Global	Name	service
Name server address	INA→ Configure→ Global	Primary			name	server
WAN port address	INA→ Configure→ Ports, Sync	Local		IP	address
	ports, Edit
Remote router address	INA→ Configure→ Ports, Sync	DestinationIP
	ports, Edit	address
Remote router	INA→ Configure→ Ports, Sync	Netmask
netmask	ports, Edit
Channel rate	INA→ Configure→ Lines,	Rate,		Save
	line0,→ Edit→ Groups→ Edit
Protocol	INA→ Configure→ Ports, Sync	PPP	or	Frame
	ports, Edit
DLCI list source	INA→ Configure→ Ports, Sync	Keep	Alive
(Frame Relay only)	ports, Edit	LMI, Annex-D or
		manual
DLCI Keepalive Value	INA→ Configure→ Ports, Sync	Keepalive interval
(Frame Relay only)	ports, Edit
DLCI list (Frame Relay		DLCI	number,			IP
only)		address
DHCP server address	INA→ Configure→ DHCP	Select the checkbox
		to enable
DHCP lease time	INA→ Configure→ DHCP	Lease
DHCP static binding IP	INA→ Configure→ DHCP→	IP address,				MAC
addresses and	Bindings→ Add	address
corresponding MAC
addresses
DHCP address pool	INA→ Configure→ DHCP	IP pool			addresses
start address and end
address

6-6 INA Module Installation and Configuration Guide