Lucent Technologies Network Access Module manual Connect an Ethernet Cable, Observe LED Behavior

Observe LED Behavior

Figure 3-4T1/PRI Connection

D

S 1

M

O

N

M

O

N

T1/PRI port

1210-003

Connect an Ethernet Cable

Use a category 5 twisted pair cable, as specified by the EIA/TIA-568-B wiring standard, with an RJ-48C connector to connect the INA Ethernet connector (Figure 3-5) to the nearest network hub. See “Ethernet Interface” on page B-2for more information.

Figure 3-5Ether0 Connection

E

T

H

E

R

N E T

Ethernet port (Ether 0)

1210-004

Observe LED Behavior

Check the T1/PRI, system, and Ethernet LEDs to verify that the installed INA module is operating properly.

T1/PRI LEDs

These LEDs (Figure 3-6) indicate the status of the T1/PRI line and operate in the same way as on a 100D module. Make sure they indicate that the T1/PRI line is operating properly.

3-4 INA Module Installation and Configuration Guide