Lucent Technologies Network Access Module manual Using the DS-1 Test Jacks

		Using the DS-1 Test Jacks
Table A-2Interpreting Diagnostic Boot Messages (Continued)
Field	Possible Message	Explanation
Setting up ACC 2188 PCI Controller		PCI memory has been
Found 16384K PCI Memory at 0x1ffff000		correctly set up.
Testing PCI Memory block 0x20000000-
0x20ffffff ...Passed
Total of 16384K PCI Memory Ready
block alloc 425 870400
block_alloc: cpu<0> control 0028bdb0
free_count<425>
PM3VT/Legend ComOS V4.15.a4.		ComOS version string.
100R HV=01 FBV=00 FAV=11 FAS=01		MERLIN firmware
		identification.
Found x ports	3	Number of ports found,
		including C0 and C1.
Ether0 active	PCI-Master	Ethernet interface found.
Running ComOS	N/A	If the system becomes
		suspended at this point
		and does not print the next
		message, the configuration
		nonvolatile RAM
		(NVRAM) has been
		corrupted. Refer to the
		PortMaster Troubleshooting
		Guide for instructions on
		nonvolatile RAM recovery.
PortMaster Console login:	N/A	System is up and running.

Using the DS-1 Test Jacks

The six test jacks provide the means to connect external test equipment to the T1/PRI line. Table A-3describes the functions of the individual jacks. Figure A-1illustrates the test jack locations. Figure A-2shows the test jack configuration.

A-5