Configuring Xprint V7.0

Predefined printers

When you have performed these steps, Xprint V7.0 suggests a default configu- ration and at the same time offers you the option of modifying this configuration:

A display similar to the following appears on the screen:

Proposal of device definition (type "HP Laserjet 4P", emulation "HP-LASERJET"):

--1 NAME: HPLJ-4P

--2 Host: colorado

--3 pcl: HP-LASERJET

--4 Address: /dev/lp0

--5 Connection type: SERIAL

--6 Protocol: XON

--7 Speed: 9600

--8 Parity: NONE

--9 Significant bits: 8

--10 Enable polling: RESET

Please type a number to update an attribute, press return to start modification processing, ’q’ to quit or ’?’ for help : 5

To modify the displayed configuration, you must select the corresponding number and confirm with "Enter". Then the corresponding entry is marked, e.g.

>> 5 Connection type: SERIAL

Confirm again with "Enter".

Then the possible parameters for the relevant option are displayed, from which you can select one by marking the number and confirming with "Enter" , e.g.:

Updating attribute: "Connection type" .

Current value: "SERIAL" Possible values are:

1.

SERIAL

2. PARALLEL

3. LAN

4.

SCSI

 

 

Type entry number (any other entry means no change) : 2

Once you have made all the settings according to your requirements, confirm with "Enter". Xprint V7.0 then confirms the entry of the new printer with the following message:

Updating device model : "HPLJ-4P" .

U23841-J-Z915-6-76

111

Page 123
Image 123
Mackie V7.0 manual Display similar to the following appears on the screen, 111