Mackie V7.0 manual Administering Xprint, Starting Xprint

Introduction to administering Xprint V7.0 Administrative tasks under Xprint

5.3.6Administering Xprint V7.0

This section describes a few basic administration tasks concerning Xprint V7.0.

If you want to...		Read...
start Xprint V7.0		section “Administering Xprint V7.0” on
		page 85
terminate Xprint V7.0		section “Administering Xprint V7.0” on
		page 86
reinitialize the Xprint V7.0		section “Administering Xprint V7.0” on
database		page 86
select a language		section “Administering Xprint V7.0” on
		page 87
enable auditing (	users only)	section “Auditing” in the appendix of the
		“Reference Manual”
enable logging (	users only)	section “Logging” in the appendix of the
		“Reference Manual”
Table 5: Basic administration tasks

Starting Xprint V7.0

Only the system administrator (root) can start Xprint V7.0 with the xpstart command on his/her local host. Every host must be started individually with this command.

When you start your local host, the following objects are activated automatically:

–all the local servers belonging to this host.

–all the local printers and the associated supervisors belonging to this host. It must be possible to activate the printers automatically (see the xpadd -dev-aacommand) and they must be controlled by active servers on the local host.

–all the remote printers and supervisors belonging to this host, provided the printers can be started automatically and are controlled by active servers on the local host.

U23841-J-Z915-6-76 85