Mitsubishi DS5000TK, DS907x SIP MCON.3 RG1, Accessed by Movx instructions on the Byte±wide bus

	USER'S GUIDE
Write Access:	Timed Access Protected. Cannot be written by the application software if
	set to 0000B by the serial loader. If a 0000B is written via the serial loader
	and the security lock is set, the Partition will become 1111B. The same will
	occur if write access is available and application software writes a 0000B. In
	addition, these bits will be set to 1111B if security lock is cleared.
MCON.3:	RG1
	One of two bits that determine the range of program space. RG0 is located
	in the RPCTL register.
Initialization:	Unaffected by watchdog, external, or power±up resets. Set to 1 on a No VLI
	reset or a clearing of the security lock.
Read Access:	Can be read at any time.
Write Access:	Cannot be modified by the application software. Can only be written via the
	Bootstrap Loader.
MCON.2:	PES
	Peripheral Enable Select. When this bit is set, the data space is controlled
	by PE1±PE4. Peripherals are memory±mapped in 16K blocks, and are
	accessed by MOVX instructions on the Byte±wide bus.
Initialization:	Cleared by all resets.
Read Access:	Can be read at any time.
Write Access:	Can be written at any time.
MCON.1:	PM
	Partition Mode. When PM=0, a partitionable, continuous memory map is
	invoked. When PM=1, one of four fixed allocations is used.
Initialization:	Unaffected by watchdog, external, or power±up resets. Cleared on a No VLI
	reset.
Read Access:	Can be read at any time.
Write Access:	Cannot be modified by the application software. Can only be modified via
	the Boostrap Loader.
MCON.0:	SL
ªSecurity Lockº:	Indicates that the security lock is set when SL=1.
Initialization:	Cleared to a 0 on a no VLI power on reset.
Read Access:	Read normally any time.
Write Access:	Can only be modified by the Lock and Unlock commands of the Bootstrap
	loader. This bit cannot be modified by the application software or by the
	Bootstrap loader Write command.

050396 40/173

41