Mitsubishi Electronics PUZ-A18NHA2, PUZ-A42NHA2-BS, PUZ-A30NHA2 Disassembly Procedure, 106, Photo

14		DISASSEMBLY PROCEDURE
PUZ-A18NHA2 PUZ-A18NHA2-BS
		OPERATING PROCEDURE			PHOTOS
			Photo 1
1. Removing the top panel, service panel, front panel and					Top panel				Top panel
back panel									fixing screws
(1)	Remove the top panel fixing screws (4 ✕ 10), one from the
	right and two from the left side, and detach the top panel.
(2)	Remove 1 service panel fixing screw (4 ✕ 10) and detach
	the service panel by pulling it downward. (See photo 1.)
									Service panel
									for charge
(3)	Remove the front panel fixing screws (4 ✕ 10), 5 from the		Grille						plug
	front, 2 from the right and 2 from the left side, and detach
	the front panel.
(4)	Remove the conduit cover and cord cover fixing screw (2			Front panel
								Service panel
	pcs. 4 ✕ 10), and detach the conduit cover and cord cover.		Photo 2
	(See photo 2.)
						Cord cover
(5)	Remove the back panel fixing screws (4 ✕ 10), 4 from the
	right and 3 from the rear side, and detach the back panel.						Conduit cover
							and cord cover
							fixing screws

				Conduit cover
2. Removing the fan motor	Photo 3	Propeller	Electrical parts box
(1) Remove the top panel. (See photo 1.)

(2)Remove the front panel. (See photo 1.)

(3)Remove 1 nut (M6, left-screw) and detach the propeller.

(4)Disconnect the connector CNF1 on the controller circuit board in the electrical parts box.

(5)Loosen the clamp for the lead wire in the motor support.

(6) Remove 4 fan motor fixing screws (4 ✕ 18) and detach the fan motor. (See photo 3.)

Nut

Photo 4 Fan motor fixing screws Clamp

Fan motor (MF1)

Motor support

Fan motor fixing screws

106