Mitsubishi Electronics PUY-A24NHA2, PUZ-A30NHA2 Turn on the Monitoring the operation data, Press

13 MONITORING THE OPERATION DATA BY THE REMOTE CONTROLLER

13-1. HOW TO "MONITOR THE OPERATION DATA"

•Turn on the [Monitoring the operation data]

CExample) Request code "004"

A

D

(3)

B

(7)

(5)

(1)

Discharge temperature 156˚F Refrigerant address "00"

A: Mode display

B: Refrigerant address

C: Data display area

(4)

(2)(6) D: Request code display area

(1) Press the	TEST	button for 3 seconds so that [Maintenance mode] appears on the screen (at A).
(2) Press the	CHECK	button for 3 seconds to switch to [Maintenance monitor].

Note) It is not possible to switch to [Maintenance monitor] during data request in maintenance mode (i.e., while "- - - -" is blinking), since no buttons are operative.

Operating the service inspection monitor

[ - - - ] appears on the screen (at D) when [Maintenance monitor] is activated. (The display (at D) now allows you to set a request code No.)

(3) Press the [TEMP] buttons (	and	) to select the desired refrigerant address.
[Screen B]

(4)Press the [CLOCK] buttons ( and ) to set the desired request code No.

(5)Press the FILTER button to perform data request.

(The requested data will be displayed at C in the same way as in maintenance mode.)

Data collected during operation of the remote controller will be displayed.

The collected data such as temperature data will not be updated automatically even if the data changes. To display the updated data, carry out step (4) again.

Canceling the Monitoring the operation data
(6) While [Maintenance monitor] is displayed, press the		CHECK button for 3 seconds to return to maintenance mode.
(7) To return to normal mode, press the	ON/OFF	button.

96