Answering Calls
To receive a call, your phone must be turned on and have a network connection with adequate signal strength. If your phone is locked, you must unlock the phone to answer the call. When you receive a call, your phone rings and/or vibrates and displays an incoming call message.
To answer an incoming call:
▶When your phone rings and/or vibrates, press N or press - (Answer). Depending on your settings, your phone notifies you of incoming calls as follows:
■An incoming call message displays.
■If available, the caller’s phone number displays.
■If the caller ID is delivered, the Phonebook Match Name is presented.
Answering a Roam Call With Call Guard Enabled
You will be notified of an incoming roam call in two ways:
⬤Incoming roam calls have a distinctive ring. (You can select the roam ring tone by pressing - [Menu], then Sounds, then Ringer Types, then Roam Ringer.)
⬤The message on your External or Main LCD will read Roam Call From instead of Call From.
To answer a call when you are roaming and Call Guard is enabled:
▶Select Answer or press N to answer the call. (See “Controlling Roaming Charges Using Call Guard” on page 72 for additional information.)
Note: If your phone is off, incoming calls will go to voicemail.
Ending a Call
To disconnect a call when you are finished:
▶Close the phone or press O.
The following options are displayed for a few seconds after you end the call. These options are located under Options.
⬤Call Again to call again if the number is available.
⬤Save Number to display Save Number menu, if the number is not in the Phone Book.
Section 2A: Your PCS Phone: The Basics | 22 |
