Cisco Systems OL-14340-01 manual Asic-scan pse ingress disable, AR-22

ASIC Driver Commands on Cisco IOS XR Software

asic-scan pse ingress disable

asic-scan pse ingress disable

To disable an ASIC scan on all causes in all blocks of a specific packet switching engine (PSE) device, use the asic-scan pse ingress disable command in EXEC mode.

asic-scan pse ingress disable location node-id

Syntax Description	location node-id	Identifies the location of the node on which to disable the
		ASIC scan. The node-idis expressed in the rack/slot/module
		notation.
		Note Use the show platform command to see the location
		of all nodes installed in the router.

Defaults

Command Modes

Command History

No default behavior or values

EXEC

Release	Modification
Release 2.0	This command was introduced on the Cisco CRS-1.
Release 3.0	No modification.
Release 3.2	No modification.
Release 3.3.0	No modification.
Release 3.4.0	No modification.
Release 3.5.0	No modification.
Release 3.6.0	Note was added in the Usage Guidelines section that this command can
	adversely affect the router operation.

Usage Guidelines To use this command, you must be in a user group associated with a task group that includes the proper task IDs. For detailed information about user groups and task IDs, see the Configuring AAA Services on Cisco IOS XR Software module of the Cisco IOS XR System Security Configuration Guide.

Note This command should be used only with Cisco support supervision. Incorrect usage of this command can accidentally remove the relevant card from service.

Task ID	Task ID	Operations
	drivers	read, write

	Cisco IOS XR Advanced System Command Reference
AR-22	OL-14340-01