ASIC Driver Commands on Cisco IOS XR Software
asic-scan pse egress enable
AR-13
Cisco IOS XR Advanced System Command Reference
OL-14340-01
asic-scan pse egress enable
To enable an ASIC scan on all causes in all blocks of a specific egress packet switching engine (PSE)
device, use the asic-scan pse egress enable command in EXEC mode.
asic-scan pse egress enable location node-id
Syntax Description
Defaults No default behavior or values
Command Modes EXEC
Command History
Usage Guidelines To use this command, you must be in a user group associated with a task group that includes the proper
task IDs. For detailed information about user groups and task IDs, see the Configuring AAA Services on
Cisco IOS XR Software module of the Cisco IOS XR System Security Configuration Guide.
Note This command should be used only with Cisco support supervision. Incorrect usage of this
command can accidentally remove the relevant card from service.
Task ID
location node-id Identifies the location of the node that hosts the egress PSE
on which to enable the ASIC scan. The node-id is expressed
in the rack/slot/module notation.
Note Use the show platform command to see the location
of all nodes installed in the router.
Release Modification
Release 2.0 This command was introduced on the Cisco CRS-1.
Release 3.0 No modification.
Release 3.2 No modification.
Release 3.3.0 No modification.
Release 3.4.0 No modification.
Release 3.5.0 No modification.
Release 3.6.0 Note was added in the Usage Guidelines section that this command can
adversely affect the router operation.
Task ID Operations
drivers read, write