ASIC Driver Commands on Cisco IOS XR Software
asic-scan egressq help-block
AR-6
Cisco IOS XR Advanced System Command Reference
OL-14340-01
asic-scan egressq help-block
To enable an ASIC scan that lists all the blocks on the specified node, use the asic-scan egressq
help-block command in EXEC mode.
asic-scan egressq help-block location node-id
Syntax Description
Defaults No default behavior or values
Command Modes EXEC
Command History
Usage Guidelines To use this command, you must be in a user group associated with a task group that includes the proper
task IDs. For detailed information about user groups and task IDs, see the Configuring AAA Services on
Cisco IOS XR Software module of the Cisco IOS XR System Security Configuration Guide.
Note This command should be used only with Cisco support supervision. Incorrect usage of this
command can accidentally remove the relevant card from service.
Task ID
Examples The following example shows how to enable an ASIC scan that lists all block numbers on the egress
queue that is located on the CPU node in slot 6:
RP/0/RP0/CPU0:router# asic-scan egressq help-block location 0/6/CPU0
location node-id Identifies the location of the node on which to enable the
ASIC scan. The node-id is expressed in the rack/slot/module
notation.
Note Use the show platform command to see the location
of all nodes installed in the router.
Release Modification
Release 3.6.0 This command was introduced on the Cisco CRS-1.
Task ID Operations
drivers read, write