ASIC Driver Commands on Cisco IOS XR Software
asic-scan pse ingress enable
To enable an ASIC scan on all causes in all blocks of a specific ingress packet switching engine (PSE) device, use the
Syntax Description | location | Identifies the location of the node that hosts the ingress PSE |
|
| on which to enable the ASIC scan. The |
|
| in the rack/slot/module notation. |
|
| Note Use the show platform command to see the location |
|
| of all nodes installed in the router. |
|
|
|
Defaults
Command Modes
Command History
No default behavior or values
EXEC
Release | Modification |
Release 2.0 | This command was introduced on the Cisco |
|
|
Release 3.0 | No modification. |
|
|
Release 3.2 | No modification. |
|
|
Release 3.3.0 | No modification. |
|
|
Release 3.4.0 | No modification. |
|
|
Release 3.5.0 | No modification. |
|
|
Release 3.6.0 | Note was added in the Usage Guidelines section that this command can |
| adversely affect the router operation. |
|
|
Usage Guidelines To use this command, you must be in a user group associated with a task group that includes the proper task IDs. For detailed information about user groups and task IDs, see the Configuring AAA Services on Cisco IOS XR Software module of the Cisco IOS XR System Security Configuration Guide.
Note This command should be used only with Cisco support supervision. Incorrect usage of this command can accidentally remove the relevant card from service.
Task ID | Task ID | Operations |
| drivers | read, write |
|
|
|
| Cisco IOS XR Advanced System Command Reference |
|
