Cisco Systems OL-14340-01 manual Asic-scan pse ingress block number, AR-20

ASIC Driver Commands on Cisco IOS XR Software

asic-scan pse ingress (block number)

asic-scan pse ingress (block number)

To run, enable, or disable a generic ASIC scan on a specific ingress packet switching engine (PSE) device block or error cause, use the asic-scan pse ingress command in EXEC mode.

asic-scan pse ingress block_number [[error_cause] [disable enable] help-cause]location

node-id

Syntax Description

Defaults

Command Modes

Command History

block_number	Identifies the block on which to enable or disable the ASIC
	scan.
error_cause	(Optional) Identifies an error cause in the specified block.
	When you include the error_cause argument in the asic-scan
	pse ingress command syntax, the command takes place on
	the specified error cause.
disable	(Optional) Disables the ASIC scan on the specified block or
	error cause.
enable	(Optional) Enables the ASIC scan on the specified block or
	error cause.
help-cause	(Optional) Displays a list of all error causes in the specified
	block.
location node-id	Identifies the location of the node hosting the ingress PSE
	device on which to run, enable, or disable an ASIC scan. The
	node-idis expressed in the rack/slot/module notation.
	Note Use the show platform command to see the location

	of all nodes installed in the router.
No default behavior or values
EXEC
Release	Modification
Release 2.0	This command was introduced on the Cisco CRS-1.
Release 3.0	No modification.
Release 3.2	No modification.
Release 3.3.0	No modification.
Release 3.4.0	No modification.
Release 3.5.0	No modification.
Release 3.6.0	Note was added in the Usage Guidelines section that this command can
	adversely affect the router operation.

	Cisco IOS XR Advanced System Command Reference
AR-20	OL-14340-01