Motorola VM9 To insert the microSD card into your phone, Replace the battery and the back cover

Models: VM9

1 250
Download 250 pages 32.42 Kb
Page 148
Image 148

To insert the microSD card into your phone:

1.With your phone powered off, remove the back cover and then remove the battery. (See “Removing the Battery” on page 27.)

2.Gently slide the microSD card into the cardholder as shown below. You should notice a faint click if it engages properly in the spring-loaded holder.

Tip:

The writing on the microSD card should face up.

3.Replace the battery and the back cover.

Note:

Make sure your battery is fully charged before using the microSD card. Your data may become damaged or unusable if the battery runs out while using the microSD card.

Be sure to use only recommended microSD cards (64MB2GB). Using non-recommended microSD cards could cause data loss and damage your phone.

130 Section 2I: Using the microSD Card

Page 148
Image 148
Motorola VM9 manual To insert the microSD card into your phone, Replace the battery and the back cover