Chapter 3: CallFinder Server Installation
Chapter 3 – CallFinder Server
Installation
This chapter shows you how to set up your
The setup process entails cabling the CF220 unit and configuring the CallFinder software. The CallFinder software resides on the CallFinder unit and does not need to be installed.
Prerequisite: Ordering the DID Line
To use the CallFinder system, you will need one or two DID (Direct Inward Dial) lines in your facility. You must order the DID line(s) from your local telephone operating company (telco). A DID line allows one phone line to be associated with multiple directory numbers. However, only one call can occur on this line at any given time.
DID lines are sold in groups. For example, a telco in New York City might offer a DID line with a set of 20 directory numbers in the range of
When ordering your DID line, ask the telco representative for these details about the DID service. These details will be important when setting up your CF220 DID Adapter.
Parameter | Value Required by |
| Telco |
Number of digits used
to designate the DID extension (usually 3, 4, 6, or 7)
Type of “DID Start” used (wink, immediate, or delay dial)
You will need this information to configure your CallFinder (see step 8 on page 25).
We Supply
•A CF220 CallFinder with
•Two power supplies – one 5Vdc and one 48Vdc
•Two common telephone cables (RJ11 at both ends)
•Two DID telephone cables (RJ11 at one end; RJ12 at other end)
•A utility software program for updating CallFinder firmware
•This printed Quick Start Guide
CF220 CallFinder User Guide | 22 |
