Multi-Tech Systems ISI5634PCI/4/8 manual Configuring Ports for NetWare Connect

ISI5634PCI/4/8 User Guide

If you have downloaded the ISI driver from the MultiTech web site onto a diskette, use this command:

COPY A:\NOVELL\AIOISIX.NLM F:\SYSTEM

To load the driver, go to the system or PC console (where the ISI card is installed) and enter the following at the prompt:

LOAD AIOISIX [port=W] [interrupt=X] [name=Y] [note=Z]

Because the ISI5634PCI models are PCI-bus cards, Netware will set up the interrupt (IRQ) and I/O address automatically.

To install the ISI card scripts, copy aiomdms.mdc to f:\system\aio\directory. Click Yes to overwrite the existing aiomdms.mdc file.

Configuring Ports for NetWare Connect

When the driver is installed, it will allocate consecutive ports for the ISI card as follows:

•8 consecutive ports for the ISI5634PCI-8

•4 consecutive ports for the ISI5634PCI-4

To set up NetWare Connect ports, enter LOAD NWCCON at the NetWare console prompt. LOAD NWCCON opens the NetWare Connect Configuration Utility. Select the appropriate menu options (modem type, speed, flow control, etc.).

Removing the Driver (Novell)

In Novell, remove file AIOISIX.NLM from the system directory and make the appropriate changes to the Autoexec.ncf file.

SCO Open Server 5 Driver Installation

The ISI driver for SCO Open Server 5 is shipped on CD-ROM (FAT file system) and can also be downloaded from the Multi-Tech web site. In both cases, the driver files are compressed (“tarred”). Users installing from the CD-ROM should begin at “To install from CD-ROM” directly below. Users installing from a floppy disk should skip down to “To install driver from floppy disk” later in this section. The filename of the SCO5 driver in its tarred form is sco50x.tar.

52