Multi-Tech Systems ISI5634PCI/4/8 manual Test Commands, Display Current Settings

	Chapter 4—AT Commands, S-Registers, Result Codes
Command: &Tn	V.54 Test Commands
Values:	n = 0, 1, 3 or 6
Default:	None
Description: &T0	Abort. Stop any test in progress.
&T1	Local analog loopback test.
&T3	Local digital loopback test.
&T6	Remote digital loopback test.
	Note: To stop a test, you must use the escape sequence
	(+++AT) before typing AT&T0.
Command: &V	Display Current Settings
Values:	n/a
Description:	Displays the active modem settings, including the
	callback security settings if callback security is enabled.
	If the setup password has been entered, it also displays
	the callback security passwords.
Command: &Wn Store Current Configuration
Values:	n = 0
Default:	None
Description: &W0	Stores current modem settings in nonvolatile memory
	and causes them to be loaded at power-on or following
	the ATZ command instead of the factory defaults. See
	also the &F command.
&W1	Clears user default settings from nonvolatile memory
	and causes the factory defaults to be loaded at power-
	on or following the ATZ command.
Command: &Yn	Select Stored Configuration for Hard Reset
Values:	n = 0
Default:	0
Description: &Y0	Select stored configuration 0 on power-up. (For
	backward compatibility with some software.)
&Y1	Not supported—responds ERROR.

85