Multi-Tech Systems ISI5634PCI/4/8 manual Error Correction Mode Selection, InactivityTimer

ISI5634PCI/4/8 User Guide

Command: \Nn	Error Correction Mode Selection
Values:	n = 0–5, or 7
Default:	3
Description: \N0	Non-error correction mode with data buffering (buffer
	mode; same as &Q6).
\N1	Direct mode.
\N2	MNP reliable mode. If the modem cannot make an MNP
	connection, it disconnects.
\N3	V.42/MNP auto-reliable mode. The modem attempts first
	to connect in V.42 error correction mode, then in MNP
	mode, and finally in non-error-correction (buffer) mode
	with continued operation.
\N4	V.42 reliable mode. If the modem cannot make a V.42
	connection, it disconnects.
\N5	V.42, MNP, or non-error correction (same as \N3).
\N7	V.42, MNP, or non-error correction (same as \N3).
Command: \Qn	Flow Control Selection
Values:	n = 0, 1, or 3
Default:	3
Description: \Q0	Disable flow control (same as &K0).
\Q1	XON/XOFF software flow control (same as &K4).
\Q2	CTS-only flow control. Not supported.
\Q3	RTS/CTS hardware flow control (same as &K3).
Command: \Tn	InactivityTimer
Values:	n = 0, 1–255
Default:	0
Description: \Tn	Sets the time (in minutes) after the last character is sent
	or received that the modem waits before disconnecting.
	A value of zero disables the timer. Applies only in
	buffer mode.
	Note: You can also set the inactivity timer by chang-
	ing the value of S30.
Command: \Vn	Protocol Result Code
Values:	n = 0, 1, or 2
Default:	1

88