
92Chapter 6 Command line interface
Configuration commands
This section describes the configuration commands available with the Passport 8683POS Module. There are two types of configuration commands:
•Module commands
•Port commands
Note: If you replace one card with another type of card, Nortel Networks recommends that you go to the root level of the CLI directory before you use any CLI commands.
config poscard commands
The config poscard command allows you to:
•Reset the module
•Enable trace messages
•Display the image filename for the Passport 8683POS Module
The syntax is:
config poscard <posslot number>
where <posslot number> is the slot number of the module in the Passport 8600 chassis.
Table 30 describes the parameters and variables for the config poscard command.