Nortel Networks 8683POS manual Config pos stg command

Chapter 6 Command line interface 97

Table 34 config pos sonet command parameters and variables

Parameters and variables	Description
clock-source <internal line>	Sets the clock source to:
	• <internal>, which means clocking is derived from on-board
		clock.
	•	<line>, which means clocking is derived from line.
	Note that if you have two connected modules, you must set both to
	internal or one to line and one to internal; do not set both to line.
framing <sonet sdh>	Sets the framing to:
	• <sonet>, which means the Synchronous Optical Network
		format, the standard format used in North America.
	•	<sdh>, which means the Synchronous Digital Hierarchy clock
		format, the standard format used in Europe.
info	Shows the last saved port settings and the next-level CLI commands.
	Note that this does not show the current settings, but the last saved
	settings.
signal label	Operational value of Path Signal Label (C2). The signal label value is
	reset when the scramble value is changed.
scramble <enable disable>	Enables or disables scrambling.
section-trace <sectiontrace>	Sets the integer that the section trace flag (j0) is set to (1...255).
z0-increment	Enables or disables z0 when the framing mode is set to SONET. This
	is a priv command - to use this command, you must be in privilege
	mode.The syntax to enter priv mode is: config/pos/<port
	number>/sonet priv

config pos stg command

Use the config pos stg command to configure STG parameters on the Passport 8683POS Module.

Using the Passport 8683POS Module