Nortel Networks 8683POS manual Config pos sonet command

96Chapter 6 Command line interface

Table 33 config pos ppp command parameters and variables

Parameters and variables	Description
bridge-admin-status <open	Enables or disables the bridge control protocol.
close>
fcs-size<32 16>	Sets the length of the redundancy check (fcs) to either 32 or 16.
info	Shows the last saved port settings and the next-level CLI commands.
	Note that this does not show the current settings, but the last saved
	settings.
ip-admin-status <open close>	Enables or disables the IP control protocol.
ipx-admin-status <open close>	Enables or disables the IPX control protocol.
ipx-route-protocol <none rip>	Sets the protocol for IPX routing.
lqr-period <interval>	Sets the link quality reporting interval. Enter time in ms.
lqr-status <enable disable>	Enables or disables link quality reporting.
lqr-threshold <threshold>	Sets the link quality reporting threshold. Enter %.
magic-number <true false>	Sets a random number (“magic number”) used in loopback detection.
	True detects loopback; false does not detect loopback.
ppp-stpmode <enable disable>	Encapsulates spanning tree BPDU packets as PPP. When enabled
	the BPDUs are encapsulated as in RFC 1638. When disabled, the
	BPDUs travel as bridged data (assuming bridge-admin-status is
	enabled).
remote-ip<ipaddr>	Sets the remote iP address.

config pos sonet command

Use the config pos sonet command to configure SONET parameters on the Passport 8683POS Module.

Table 34 describes the parameters and variables for the config pos sonet command.

209564-A